Looking for:
Vmware workstation 14 uefi boot free download |
- How to Boot VM from ISO Images/CD/DVD in VMware Workstation/vSphere? - Vinchin Backup
UEFI - Wikipedia.
How to boot from USB in VMware Workstation in UEFI mode
Do you need to route some network traffic in your lab? The instructions for setting the IPs and turning on routing are identical once the VM was deployed.
Just check out the GitHub project download page. The OVA is targeted at VMware hypervisor products, with unnecessary drivers, programs, and libraries removed. The version linked here is a direct link for the version used in this article, but newer versions may be available. If your copy of Workstation Pro is older than version 14, be sure you download the OVA with virtual hardware v11 file.
Everything will proceed smoothly, but the VM will fail to boot. When setting up Photon OS to be a software router, you must have multiple network interface cards NICs to pass traffic from one side of the network to the other. In a virtual machine, those NICs are virtual devices. To route network traffic properly, the NICs must be on different subnets. Here you can see Workstation Pro already has some networks defined. The start and end of the DHCP range is important for later, as you will want to avoid configuring a static IP within this range.
Take a note to set static IPs outside of the range here. Now, click on Change Settings to re-launch the network editor as an administrator. Next, click on the Add Network button.
For the purposes of this article, you will need two additional interfaces using different, Host-only networks. Click the Add button and select Network Adapter , as shown below. Finally, click on the Finish button. Login as the root user. If you have not already changed the root password from the default, you will be asked to do so now. Note that the default password for the root user is in the VM Description, and changeme in this version. Now run the ip addr command to display the current IP addresses of the interfaces.
Other devices or routers will be pointing to these interfaces and the last thing you want to happen is for the interface IP to change! Both eth1 and eth2 may be gateway interfaces, and therefore need to be statically assigned. Set read permissions to the configuration file via the chmod command so that systemd can read the file.
Repeat steps , as shown below for the second additional network interface, eth2. The default file, dhcp-en. Next, commit the configuration changes to systemd by restarting the systemd-networkd service. By default, Linux does not pass network traffic between interfaces called IP forwarding.
Your next step is to enable IP forwarding between the interfaces just created. Run the sysctl command to turn on IP forwarding immediately. Typically, enabling IP forwarding requires a reboot. You should see that the file contains the string 1 indicating that IP forwarding is enabled. To do so, spin up another two Photon VMs using the same technique as described earlier. Note that the exact IP addresses will be different on your machine, and you should use the same subnets as you used for ATA-Router.
Host-only networks are not given a next-hop router by DHCP. You now have a handy software router available! Or even use Photon as your next Docker host?
Why not write on a platform with an existing audience and share your knowledge with the world? Adam the Automator. Twitter Facebook LinkedIn. Table of Contents. EULA Acceptance. Name the VM and Choose a location. Information shown about the newly imported VM. The network topology. DHCP Settings for a host only network. Adding a new network. Select the next network.
Add a new network adaptor. Ensure the two new NICs are on different host-only networks. Selecting the VM. At first logon you are required to change your password. Showing the Ip Address information. Check the config files. New IP addresses on Eth1 and Eth2 interfaces. Confirm IP forwarding enabled. Checking IP information. Successful Ping, no packet loss.
Subscribe to Adam the Automator for updates:. Meet Our Sponsors. Looks like you're offline!
No comments:
Post a Comment